Every spray rig has one part that gets replaced more often than the rest. It is not the pump. It is not the nozzle. It is the hose — the line that runs from the tank to the boom, gets dragged over gravel, and takes the pressure spike every time the pump kicks in.
This PVC high pressure spray hose is built for that line. It is a pressure hose, made to move air, water, herbicides, pesticides, fertilizers and light chemicals from a pump to a sprayer system. It comes in six inner diameters, from 1/4 inch to 3/4 inch, and in two pressure tiers. Working pressure runs from 20 bar to 50 bar (300 to 750 psi).
The part that matters on site is not the highest number in the range. It is picking the right number. At 1/4, 5/16 and 3/8 inch, the standard tier is rated 30 bar. At 1/2 inch and above, the same standard tier is rated 20 bar — bigger bore, less pressure in the wall. Go up one size for more flow and you can lose working pressure without noticing. That is the mistake this hose’s rating table is designed to prevent.
Burst pressure runs from 60 bar to 150 bar (900 to 2250 psi). On most models that is three times the working pressure. On the three smallest standard models it is two times, which is still a margin, but a smaller one. A fleet that writes 3:1 into its purchasing spec should specify the high-pressure tier at those sizes.
Weight is where the daily difference shows. The lightest model weighs 90 grams per metre. The heaviest weighs 570. Coil lengths follow the weight: 100 metres for the sizes up to 13 mm, 50 metres for 16 mm and 19 mm. A 100-metre coil of 1/4 inch weighs about 9 kilos, and one man carries it. A coil of 3/4 inch high pressure in the same length would weigh 57 kilos, which is why it is not made. The 50-metre coil comes in near 28 kilos, and it still takes two people.
The hose is flexible enough to bend around a boom or a reel without a formed elbow, and it coils flat into a truck box at the end of the day.
The outer cover is compounded for abrasive wear. Spray hoses are dragged across concrete, bent over the edge of a frame, and run along the ground between rows. Abrasion retires more hoses than pressure does, so the cover is where the wear resistance was put. The tube and cover also tolerate the chemistry the hose is meant to carry — insecticides, fertilizers and similar farm inputs. Concentrated products, strong solvents and aggressive acids are outside that scope, and a safety data sheet always outranks a brochure.
The working temperature range is -5°C to +65°C. Inside that range the hose holds its shape and its ratings. Cold mornings do not make it brittle. A hot afternoon in a greenhouse does not soften it into a kink. Outside the range, the rating stops applying, which rules out steam and hot-water washdown.
This hose is used in many places:
- Booms and spray lines on agricultural and horticultural sprayers
- Grounds care and roadside vegetation control
- Vehicle and yard washing in municipal fleets
- Light industrial washdown and tank feeding
- Greenhouse and orchard spraying with fertilizer and pesticide mixes
It is a pressure hose, not a suction hose. Pulling from a tank or holding vacuum is a different job and needs a different product.
For a spray operation, the value is simple. Six bores and two tiers cover most of a fleet, from a 6 mm boom line to a 19 mm tank feed, with every rating written down instead of guessed. The hose costs a little more than the cheapest tubing on the shelf. It also stops being the reason a spraying window gets interrupted.
The best equipment is the equipment you stop thinking about. This hose is built to be that.
Post time: Nov-16-2026